Equipment Inspection
Condition assessment and inspection of mechanical equipment and structures.
Mechanical Installation
Installation of mechanical equipment — positioning, grouting, alignment, coupling and commissioning support — with alignment verified and recorded rather than eyeballed.
02 / OVERVIEW
What this service is for
Installation determines how long the machine lasts. Soft foot, poor alignment and pipe strain destroy bearings and seals long before the equipment itself is at fault.
We check and record the conditions that shorten equipment life, and correct them before the machine is handed over running.
03 / SCOPE
What is included
- Equipment setting, levelling and grouting
- Shaft alignment and soft foot correction
- Coupling installation and pipe strain checks
- Baseplate and foundation preparation
- Commissioning support and handover testing
SRV-06 · Mechanical Installation
04 / APPROACH
How we run it
Verification
Alignment is recorded
Final alignment figures are recorded and handed over, so the baseline exists when the machine is next opened.
Life
Installed to last
Pipe strain and soft foot are corrected at installation, not diagnosed after the first bearing failure.
05 / DELIVERY
The sequence this runs to
The depth changes with the size of the job. The sequence does not.
Assessment
Site attendance, condition survey and failure analysis. We establish what the equipment is actually doing before anyone proposes a fix.
Engineering
Technical solution defined against the operating envelope — loads, tolerances, materials and access constraints.
Planning
Method statement, risk assessment, parts, tooling and manning scheduled against your shutdown window.
Execution
Work carried out by mechanical technicians under a written procedure, with hold points recorded as they are passed.
Installation
Components installed to the written method — alignment, clearances and torque set against the drawing, with hold points signed as they are passed.
Commissioning
Controlled start-up and function checks under operating conditions, before the asset is declared ready.
Testing
Function testing, alignment verification and performance checks before the asset is handed back.
Handover
Documented completion — what was found, what was done, what was replaced, and what to watch.
06 / RELATED
Often taken together
Engineering Support
Embedded mechanical engineering capability for teams without it in-house.
Mechanical Engineering
Design, analysis and technical support for mechanical systems operating under real industrial loads.
07 / ENQUIRE
Discuss mechanical installation for your asset.
Send the equipment details and the timescale. You will get a straight answer on scope and feasibility.